Skip to content
Rexgear_Itech IT6720 Digital Control DC Power Supply 60V 5A 100W
Rexgear_Itech IT6720 Digital Control DC Power Supply 60V 5A 100W
Rexgear_Itech IT6720 Digital Control DC Power Supply 60V 5A 100W
Rexgear_Itech IT6720 Digital Control DC Power Supply 60V 5A 100W
Rexgear_Itech IT6720 Digital Control DC Power Supply 60V 5A 100W
Rexgear_Itech IT6720 Digital Control DC Power Supply 60V 5A 100W

ITECH IT6720 Digital Control DC Power Supply 60V 5A 100W

IT6700 series power supplies are the most economical power supplies, they have the widest voltage and current utilization, one power supply can replace multiple power supplies, widely used in various testing occasions. With the capacity of 100W, voltage output of 60V, current output of 5A, they can control the change rates of the voltage and current automatically. The power ratio can be up to 3 times. For instance, One IT6720 can substitute previous 60V*1.6A/32/*3A/20V*5A 3 kinds of models to save your cost.

Features

  • The most economical high performance completely digital-control power supplies
  • 10mV/1mA high accuracy and resolution
  • Lower noise and ripple
  • CV/CC modes
  • Minimum size to save space
  • LED display
  • OCP/OVP/OTP protection
  • Full scale 60V/5A,resolution 10mV/1mA,no need to switch
  • On/off controlling

Widest voltage and current utilization

IT6700 series can control voltage and current automaticly.The power ratio can be up to 3 times.For instance,one IT6720 can subsitute previous 60V*1.6A/32/*3A/20V*5A 3 kinds of models to save your cost.

Quick Start

Setting the voltage

Press to light up to the voltage setup indicator B. It means IT6720 is in voltage set mode, shown as fig 1. Press Press_Voltage_A-B light up the voltage setup indicator Indicator_B Now the voltage will rise/decline 1V once you rotary the knob analog. Set the voltage to 12V.

Setting the current

Press to light up to the voltage setup indicator B. It means IT6720 is in voltage set mode, shown as fig 1. Press Press_Voltage_A-B light up the voltage setup indicator Indicator_B Now the voltage will rise/decline 1V once you rotary the knob analog. Set the voltage to 12V.

Enable output

Press On_off to enable the IT6720 output. Voltages and current settings will be wink for three seconds, and after that , the display value of numerical display value from the set value to actual measured voltage and current value. Power lights will be turned off which means the power is in output state. Press On_off again, you will shut power supply's output

Use by: